Alpha Bridge AB-QSFP28-40R Datasheet
Features
- QSFP28 MSA package with simplex LC connector
- Compliant to 100G Lamda MSA 100G-ER1 Optical Specifications
- Lane signaling rate 53.125GBd with PAM4
- High speed I/O electrical interface
- Two Wire Serial Interface with Digital Diagnostic Monitoring
- Operating case temperature range: 0°C to +70°C
- Support KP4 FEC inside the module and KP4 FEC shutdown
- Reaches up to 40km on SMF
- Maximum power consumption 4.5W
- 3V power supply voltage
- compliant to RoHS2.0
- Class 1 Laser
Applications
- 100 Gigabit Ethernet
- Data Center
Absolute Maximum Ratings
| Parameter | Symbol | Conditions | Min. | Max. | Unit |
| Storage temperature (case) | Tstg | - | -40 | +85 | ℃ |
| Relative Humidity | RH | Noncondensing | 5 | 85 | % |
| Supply voltage | VCC | 0 | 3.6 | V | |
| Low speed signal voltage range | -0.3 | 4.0 | V | ||
| Damage threshold | Pin | Average | 5.5 | dBm | |
| ESD Sensitivity | — | ±500V for RF ±2kV for others | V |
Recommended Operating Conditions
| Parameter | Symbol | Min. | Typical | Max. | Unit |
| Operating Case Temperature | Tcase | 0 | - | 70 | ℃ |
| Supply Voltage | VCC | 3.135 | 3.3 | 3.465 | V |
| Relative Humidity | RH | 5 | - | 85 | % |
| Power Dissipation | PD | - | - | 4.5 | W |
| Data Rate (Optical) | DRO | - | 103.125 | 106.25 | Gbps |
| Data Rate (Electrical) | DRE | - | 26.5625 | - | Gbps |
| Operating Link Distance | LD | - | - | 40 | Km |
Optical Characteristics
| Parameter | Symbol | Condition | Min. | Typ. | Max. | Unit | Note |
| Transmitter | |||||||
| Data Rate | 103.125 | 106.25 | Gbps | ||||
| Data rate variation | -100 | +100 | ppm | ||||
| Lane center wavelength | 1304.06 | 1304.58 | 1305.1 | nm | |||
| 1308.61 | 1309.14 | 1309.66 | nm | ||||
| Launch power per lane | Peach | 1.5 | 7.1 | dBm | 1, 2 | ||
| Optical modulation amplitude per lane | POMA | For TDECQ <1.4dB | 4.5 | 7.9 | dBm | ||
For 1.4dB< TDECQ
|
3.1+ TDECQ |
|
7.9 |
|
|
| ||
| Transmitter and Dispersion eye closure | TDECQ | 3.9 | dBm | ||||
| Optical Extinction Ratio | ER | 5 | dB | ||||
| Side mode Suppression ratio | SMSR | 30 | dB | ||||
| Launch power of OFF Transmitter per lane | -30 | dBm | |||||
| Relative Intensity Noise | RIN | -136 | dB/Hz | ||||
| Optical return loss tolerance | 15.6 | dB | |||||
| Transmitter reflectance | -26 | dB | 4 | ||||
| Receiver | |||||||
| Data Rate | 103.125 | 106.25 | Gbps | ||||
| Data rate variation | -100 | +100 | Ppm | ||||
| Lane center wavelength | 1308.61 | 1309.14 | 1309.66 | nm | |||
| 1304.06 | 1304.58 | 1305.1 | nm | ||||
| Damage threshold | Rdam | -2.4 | dBm | 5 | |||
| Average receiver power | Rpow | -16.2 | -3.4 | dBm | 6 | ||
| Receiver Power (OMA) per lane | Rovl | -2.6 | dBm | ||||
Electrical Specifications
| Transmitter (Module Input) | |||||
| Parameter | Symbol | Min. | Typical | Max. | Unit |
| Input Differential Impedance | Rin | - | 100 | - | Ohm |
| Differential termination mismatch (max) | Dmismatch | - | - | 10 | % |
| Differential Data Input Amplitude | VIN, P-P | - | - | 900 | mVpp |
| LP Mode, Reset and ModSelL | VIL | -0.3 | - | 0.8 | V |
| VIH | 2.0 | - | VCC+0.3 | V | |
| Receiver (Module Output) | |||||
| Output Differential Impedance | Rout | - | 100 | - | Ohm |
| Differential termination mismatch (max) | Dmismatch | - | - | 10 | % |
| Differential Data Output Amplitude | VOUT, P-P | - | - | 900 | mVpp |
| ModPrsL and IntL | VOL | 0 | - | 0.4 | V |
| VOH | VCC-0.5 | - | VCC+0.3 | V | |
Pin Descriptions
| Pin no. | Logic | Symbol | Description | Note |
| 1 | GND | Ground | 1 | |
| 2 | CML-I | Tx2n | Transmitter Inverted Data Input | |
| 3 | CML-I | Tx2p | Transmitter Non-Inverted Data Input | |
| 4 | GND | Ground | 1 | |
| 5 | CML-I | Tx4n | Transmitter Inverted Data Input | |
| 6 | CML-I | Tx4p | Transmitter Non-Inverted Data Input | |
| 7 | GND | Ground | 1 | |
| 8 | LVTLL-I | ModSelL | Module Select | 3 |
| 9 | LVTLL-I | ResetL | Module Reset | 4 |
| 10 | VccRx | +3.3V Power Supply Receiver | 2 | |
| 11 | LVCMOS-I/O | SCL | 2-Wire Serial Interface Clock | 3 |
| 12 | LVCMOS-I/O | SDA | 2-Wire Serial Interface Data | 3 |
| 13 | GND | Ground | 1 | |
| 14 | CML-O | Rx3p | Receiver Non-Inverted Data Output | |
| 15 | CML-O | Rx3n | Receiver Inverted Data Output | |
| 16 | GND | Ground | 1 | |
| 17 | CML-O | Rx1p | Receiver Non-Inverted Data Output | |
| 18 | CML-O | Rx1n | Receiver Inverted Data Output | |
| 19 | GND | Ground | 1 | |
| 20 | GND | Ground | 1 | |
| 21 | CML-O | Rx2n | Receiver Inverted Data Output | |
| 22 | CML-O | Rx2p | Receiver Non-Inverted Data Output | |
| 23 | GND | Ground | 1 | |
| 24 | CML-O | Rx4n | Receiver Inverted Data Output | |
| 25 | CML-O | Rx4p | Receiver Non-Inverted Data Output | |
| 26 | GND | Ground | 1 | |
| 27 | LVTTL-O | ModPrsL | Module Present | |
| 28 | LVTTL-O | IntL/RX_LOS | Interrupt/Rx LOS | 5 |
| 29 | VccTx | +3.3 V Power Supply transmitter | 2 | |
| 30 | Vcc1 | +3.3 V Power Supply | 2 | |
| 31 | LVTTL-I | LPMode/Tx_DIS | Low Power mode/Tx Disable | 5 |
| 32 | GND | Ground | 1 | |
| 33 | CML-I | Tx3p | Transmitter Non-Inverted Data Input | |
| 34 | CML-I | Tx3n | Transmitter Inverted Data Input | |
| 35 | GND | Ground | 1 | |
| 36 | CML-I | Tx1p | Transmitter Non-Inverted Data Input | |
| 37 | CML-I | Tx1n | Transmitter Inverted Data Input | |
| 38 | GND | Ground | 1 |
Ordering Information
| Part Number | Product Description |
| AB-QSFP28-40R | QSFP28 100G BiDi ER1, 40km,EML+APD, Tx1309nm/Rx1304nm, SMF, Simplex LC, 0°C to +70°C |

