Alpha Bridge ASFP-10G-T100-I Datasheet
Features
- Up to 10Gb/s bi-directional data links
- Hot-pluggable SFP+ footprint
- Fully metallic enclosure for low EMI
- Low power dissipation
- Compact RJ-45 connector assembly
- Access to physical layer IC via 2-wire serial bus
- Supports Links up to 100m using Cat 6a/7 Cable
- RoHS Compliant
- Operating case temperature: -40℃ to 85℃
Applications
- 10 Gigabit Ethernet over Cat 6a/7 cable
Description
ASFP-10G-T100-I Copper Enhanced Small Form Pluggable (SFP+) transceivers are high-performance, cost-effective module compliant with the 10G Ethernet and 10GBASE-T standards as specified in IEEE 802.3az, which supporting 10Gbps data- rate up to 100 meters reach over unshielded twisted-pair category 6a/7 cables. The module provides standard serial ID information compliant with SFP+ MSA, which can be accessed with address of A0h via the 2wire serial EEPROM protocol.
+3.3V Volt Electrical Power Interface
| Parameter | Symbol | Min | Typ. | Max | Units | Notes/Conditions |
| Supply Current | Is | 900 | mA | 2.5W max power over full range of voltage and temperature. See caution note below | ||
| Input Voltage | Vcc | 3.13 | 3.3 | 3.47 | V | Referenced to GND |
| Maximum Voltage | Vmax | 3.8 | V | |||
| Surge Current | Isurge | 30 | mA | Hot plug above steady state current. |
General Specifications
| Parameter | Symbol | Min | Typ. | Max | Units | Notes/Conditions |
| Data Rate | BR | 10.3 | Gb/sec | IEEE 802.3 compatible. | ||
| Cable Length | L | 100 | m | Category 6a/7 UTP. BER <10-12 |
Environmental Specifications
| Parameter | Symbol | Min | Typ. | Max | Units | Notes/Conditions |
| Operating Temperature | Top | -40 | 85 | °C | Case temperature | |
| Storage Temperature | Tsto | -40 | 85 | °C | Ambient temperature |
Pin Definitions
| Pin | Signal Name | Description | Plug Seq. | Notes |
| 1 | VEET | Transmitter Ground | 1 | |
| 2 | TX FAULT | Transmitter Fault Indication | 3 | Not supported |
| 3 | TX DISABLE | Transmitter Disable | 3 | |
| 4 | SDA | SDA Serial Data Signal | 3 | |
| 5 | SCL | SCL Serial Clock Signal | 3 | |
| 6 | MOD_ABS | Module Absent. Grounded within the module | 3 | |
| 7 | RS0 | Not Connected | 3 | |
| 8 | LOS | Loss of Signal | 3 | |
| 9 | RS1 | Not Connected | 3 | |
| 10 | VEER | Receiver ground | 1 | |
| 11 | VEER | Receiver ground | 1 | |
| 12 | RD- | Inv. Received Data Out | 3 | |
| 13 | RD+ | Received Data Out | 3 | |
| 14 | VEER | Receiver ground | 1 | |
| 15 | VCCR | Receiver Power Supply | 2 | |
| 16 | VCCT | Transmitter Power Supply | 2 | |
| 17 | VEET | Transmitter Ground | 1 | |
| 18 | TD+ | Transmit Data In | 3 | |
| 19 | TD- | Inv. Transmit Data In | 3 | |
| 20 | VEET | Transmitter Ground | 1 |
Ordering information
| Part Number | Tx_DIS | Link Indicator on Rx_LOS Pin | Temp. |
| ASFP-10G-T100-I | Yes | Yes | -40~85°C |
